Carburetor Disassembly - Arctic Cat Cougar Service Manual

FUEL SYSTEM-CARBURETED MODELS
Disassembly
Refer to Figure 10 for this procedure.
NOTE
Because the jetting between the carbu-
retors may be different, store the compo-
nents for each carburetor in a separate
box.
215
1. Before removing the pilot air screw ( 19, Fig-
ure 10), count the turns while screwing it in un-
til it seats lightly. Record the original exact
position, then back the screw out and remove it
and the spring from the carburetor.
2. Remove the screws attaching the float bowl
to the carburetor housing. Remove the float
bowl (Figure 11) and bowl gasket.
CARBURETOR
1. Cap
2. Spring
3. Plate
4. Washer
5. E-clip
6. Washer
7. Jet needle
8. Throttle valve (slide)
9. Needle jet
10. Housing
11. Starter plunger cap
12. Lockplate
13. Spring
14. Plunger (choke)
15. Hose
16. Idle speed stop screw
17. Spring
18. Spring
19. Pilot air screw
20. Washer
21. Main jet
22. Pilot jet
23. Washer
24. Plate
25. Fuel inlet needle seat
26. Needle valve
27. Retainer clip
28. Pin
29. Float arm
30. Float
31. Gasket
32. Float bowl
33. Hose guide
34. Lockwasher
35. Screw
36. Gasket
37. Drain plug
28
36---<r"'l
37--l~
19