Arctic Cat Cougar Service Manual page 226

216
3. Remove any loose baffle rings (Figure 12)
that may be located around the main jet.
4. Remove the pivot pin and float arm (28 and
29, Figure 10).
5. Remove the retainer clip from the needle
valve. See Figure 13.
6. Lift the fuel inlet needle from the seat, then
unscrew the seat. A baffle plate and gasket (Fig-
ure 14) are located under the inlet valve seat.
CAUTION
You can easily damage the pilot jet
if
you
use the wrong size of screwdriver to re-
move or install the jet.
7. Remove the pilot jet (Figure 15) using a flat
tip screwdriver with straight sides that fits the slot
in the jet correctly.
8. Remove the main jet (Figure 16).
9. Remove the needle jet through the top of the
carburetor (Figure 17).
®
CHAPTER
SIX