Arctic Cat Cougar Service Manual page 468

458
3A. If a collar is located as shown in Figure 30,
loosen the set screw and remove the collar.
3B. If an offset pivot lever is located as shown in
Figure 31, remove the lever as follows:
NOTE
It is important to mark the position of the
lever in substep a before removing it to
aid in assembly.
a. Mark the shaft in line with the slots in the
lever.
b. Remove the pinch bolts that clamp the lever
to the shaft.
CAUTION
The shaft can be damaged
if
the offset
pivot is pulled from the shaft splines in
substep c without removing the pinch
bolts. The axle is notched to allow clear-
ance for the pinch bolts.
c. Pull the lever from the shaft. Be careful not
to lose the pivot shaft and axle (Figure 32).
4. Attach a suitable puller (Figure 33) and pull
the wheel from the pivot shaft.
5. Installation is the reverse of removal, observ-
ing the following:
a. Install the spring and spring sleeve (38 and
39, Figure 16). Install the spring slide (B,
Figure 10 or Figure 29).
b. Tighten the bolt attaching the spring slide
to the torque listed in Table 1.
c. Use a driver Figure 34 that contacts only
the inner race of the bearing to install the
idler wheel. Make sure the bearing is seated.
d. Install spacers and thrust washers, as
re~
quired. A spacer and thrust washer may be
located between the idler wheel and the
collar (Figure 30) or offset pivot (Figure
31) on some models.
e. If so equipped, install the axle and washer
in the offset pivot (Figure 35). The notched
side of the offset pivot should be toward the
inside.
f. If equipped with the offset pivot, align the
split with the alignment marks made on the
CHAPTER SIXTEEN