Driveshaft Service - Arctic Cat Cougar Service Manual

384
4. Install the bearing (Figure 20) on the left
(engine PTO) end of the driven shaft.
5. Insert the driven shaft through the brake disc
hub, engaging the key with the keyway in the
hub.
6. Check that the driven shaft is centered, then
install the flange plates against the side pan
(Figure 12 or Figure 17). Tighten the retaining
bolts to the torque listed in Table 2.
7. Slide the lock collar toward the bearing, but
do not lock it.
8. Apply Scotch Bond Adhesive 4174 to the
bearing seating area adjacent to the shaft splines.
9. Install the bearing, seal and flange plate on
the dropcase housing side. Tighten the flange
plate retaining nuts to the torque listed in Table
2.
10. Slide the lock collar against the bearing and
tum the collar in the direction of rotation ( oppo-
site the direction shown in Figure
16)
to lock the
collar.
11. Tighten the setscrew (Figure 15) in the lock
collar.
CHAPTER FOURTEEN
12. Install the driven pulley as described in
Chapter Thirteen. Align the pulleys and set the
belt deflection as necessary.
13. Install the sprockets and chain as described
in this chapter.
14. Install the drive belt and covers.
DRIVES HAFT
The driveshaft is driven by the chain in the
dropcase located on the right side. Refer to Fig-
ure 22 when performing procedures in this sec-
tion.
Removal
1. Remove the chain and sprockets as described
in this chapter.
2. Remove the driven pulley as described in
Chapter Thirteen.
3. Remove the skid frame of the rear suspension
from the tunnel as described in Chapter Sixteen.
@
DRIVESHAFT
4 5 6 7 8 10 12 11
1. Driveshaft 7. Bearing
2. Outer drive sprockets 8. Flange plate
3. Inner drive sprockets 9. Cable adapter
4. Bushing 10. Speedometer cable drive
5. Carriage bolt 11. Grease fitting
6. Flange plate 12. Nut