Throttle Cable Service; Console Switches View - Arctic Cat Cougar Service Manual

FUEL SYSTEM-FUEL-INJECTED MODELS
typical, when attaching the wiring harness to the
switches in the console.
NOTE
Be sure to attach the supply and return
hoses to the correct fittings.
15. Check all hoses and connections for leaks.
Cleaning/inspection
You must remove the fuel tank to thoroughly
clean and inspect it.
WARNING
Clean the fuel tank in an open area away
from all sources of flames or sparks.
1. Pour old gasoline from the tank into a sealable
container manufactured specifically for gasoline
storage.
247
2. Pour about 1 quart of fresh gasoline into the
tank and slosh it around for several minutes to
loosen sediment. Pour the contents into a seal-
able container.
3. Examine the tank for cracks and abrasions,
particularly at points where the tank contacts the
body. Areas that rub can be protected and cush-
ioned by coating them with a nonhardening sili-
cone sealer. Allow it to dry before installing the
tank. If abrasion is extensive or if the tank is
leaking, replace it.
Throttle Cable
Replacement
The throttle cable uses a junction for cables
branching to the throttles and the oil injection
pump. When replacing the throttle cable, observe
the following:
®
CONSOLE SWITCHES (TYPICAL)
Main harness
thumbwarmer
connector
(thin black)
Main harness
thumb warmer
connector
Thumblhandwarmer
switch
Main harness
connector
(brown/brown)
Ignition switch
Main harness
connector (green)
EFI main harness
connector (red/black)
EFI main harness
connector (red/yellow)