Arctic Cat Cougar Service Manual page 34

24
removed before the crankcases can be split.
There is no satisfactory substitute for this tool.
Because the flywheel is a taper fit on the crank-
shaft, makeshift removal often results in crank-
shaft and flywheel damage. Do not attempt
removal of the flywheel without this tool. A
puller can be ordered through Arctic Cat dealers.
Strap Wrench
A strap wrench (Figure 56) can be used to
hold the flywheel when loosening the flywheel
retaining nut.
Starter Pulley Holder
A universal type holder (Figure 57) or the
universal Grabbit (Figure 58) can be used to
hold the recoil starter pulley during removal and
installation.
Bearing Pullers
A bearing puller set with long arms (Figure
@)
59) is valuable help for removing bearings from
suspension wheels and other locations.
Track Clip Installer
A track clip installer (Figure 60) is required
to install track clips.
Spring Scale
A spring scale (Figure 61) is required to check
track tension.
Clutch Tools
A number of special tools are required for
clutch service. These are described in Chapter
Thirteen.
®
CHAPTER ONE
FLYWHEEL PULLER