Arctic Cat Cougar Service Manual page 162

152
a. Disconnect the springs (Figure 5 or 6, typi-
cal) that hold the exhaust pipe(s) to the
muffler.
b. Disconnect the springs that hold the exhaust
pipe(s) to the exhaust sockets (Figure 7) or
to the manifold (Figure 8).
c. Disconnect any clamps or springs that re-
tain the exhaust pipe(s), then remove the
exhaust pipe(s).
3. Remove the drive belt as described in Chapter
Thirteen.
4. Remove both the drive and driven pulleys as
described in Chapter Thirteen.
5. On liquid-cooled models, drain the cooling
system as described under Coolant Change in
Chapter Three.
6. Disconnect spark plug cables from the spark
plugs.
7. Remove the recoil starter as described in
Chapter Twelve.
8. Remove the air silencer as described in Chap-
ter Six or Chapter Seven.
NOTE
Mark the carburetors for identification.
The two or three carburetors may appear
to be identical, but may have different
jetting. Even
if
they are identical, the
throttle slides and starting enrichment
slides should be reinstalled in the carbu-
retor from which they were removed.
9 A. On engines equipped with carburetors, ob-
serve the following:
CAUTION
It is not necessary to remove the throttle
slides (sub step a) or starting enrichment
valves ( substep b) from the cables unless
service to these parts is required. Insert
each slide and valve in a plastic bag to
protect them from damage, then tie the
cables, caps, slides and valves out of the
way.
a. Unscrew the carburetor caps (Figure 9) and
withdraw the throttle valves (slides) from
CHAPTER FIVE