Before Placing Tumble Dryer Into Service - ALLIANCE CA050L Installation Operation & Maintenance

1
7
6
1. Screw Cable Clamp
2. Beginning Location of Door Switch Harness
3. Original Switch Location
4. Lint Panel Switch Harness
5. Wire Ties
6. Original Plug Location
7. Top Panel
9. Place front panel on machine, loosely attach four bottom
screws. Connect door switch harness to switch in new loca-
tion. Install door assembly and four front panel side screws
loosely. Refer to Figure 13 .
10. Check lint panel fit, adjusting front panel up or down as re-
quired. Tighten four front panel side screws to maintain posi-
tion of front panel for proper lint panel clearance.
11. Remove lint panel. Fully tighten bottom screws on front pan-
el.
12. Reinstall top screws and guide lugs.
13. Adjust door catch if necessary to allow 7 – 15 pounds [0.48 –
1.03 bar] pull at center of handle.
14. Reinstall control assembly using mounting screws.
15. Reinstall control panel and lint panel.
IMPORTANT: Restore power to tumble dryer and
test for proper operation of loading door switch.
Tumble dryer should not start with door open; an
operating tumble dryer should stop when door is
opened.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
2
5
3
4
TMB1996N_SVG
Figure 12
1
4
1. Switch (New location)
2. Plug (New location)
3. Door Assembly
4. Side Screw
NOTE: If machine is converted back to right hand hinge
operation, the door switch harness must be rerouted.
Before Placing Tumble Dryer into Serv-
ice
1. Remove or open all panels and check accessible bolts, nuts,
screws, terminals and fittings for tightness.
2. Check belt tension and adjust if necessary. Refer to Adjust-
ments section.
3. Replace all panels and guards.
4. Turn on electrical supply to tumble dryer.
5. Open the supply valve for gas or steam heated tumble dryers.
6. After performing the previous checks, start the tumble dryer
by pressing START. (Refer to the Operating section for de-
tailed instructions.) Release the start button and open the
loading door. The cylinder should stop rotating within seven
seconds after the door is opened a maximum of 2 inches [51
mm]. If it does not, adjust the loading door switch. Refer to
Adjustments section.
7. Gas Tumble Dryers: Start the tumble dryer and check the
burner flame. Adjust the air inlet shutter as required. Refer to
Adjustments section.
29
3
TMB1997N_SVG
Figure 13
Part No. 70457901ENR12
Installation
2