Dx4 Coin Control - ALLIANCE CA050L Installation Operation & Maintenance

UO and RU Control Suffixes
1. Press the
or keypad to change cycles. The center
highlighted position is the selected cycle.
To customize a cycle, refer to the Programming Manual.
2. Press START
to start selected cycle.
IMPORTANT: If the loading door or lint panel door is
opened during the cycle, the heating system will
shut off and the motor will stop. To restart the cycle,
both doors must be closed and the START
must be pressed.
3. When the cycle is complete, open door and remove laundry.
To prevent the risk of fire, remove laundry imme-
diately in case of power failure.

DX4 Coin Control

3B, 3K, 3L, 3V, 3W and 3X Control Suffixes
1. Open door and fill drum with clothes.
2. Close door.
3. Insert the coin(s) in the coin slot.
4. Press and release one of the cycle buttons to select a cycle and
start the tumble dryer. Refer to Table 15 .
To use a custom cycle, refer to the Programming Manual.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
WARNING
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle is
complete, the cylinder will tumble without heat ev-
ery few minutes. The intermittent tumbling will con-
tinue for one hour or until the door is opened. After
an hour the machine enters delayed tumble and will
tumble for two minutes every hour for up to 18
hours or until the door is opened.
pad
W779
TMB1276C_SVG
Figure 56
79
Operating Instructions
TMB2266N_SVG
Figure 57
Part No. 70457901ENR12