Dmp Coin - ALLIANCE CA050L Installation Operation & Maintenance

Operating Instructions
Fun
ctio
n OPL
4 Empty
5 Empty
6 Buzzer Timer
7 Safety Tumble (OPL) or Coin
Count/Pay (Coin)
8 Programming
DIP Switch Functions Explained
1. Tumble dryer Type: This DIP switch selects the type of tum-
ble dryer, i.e., OPL or Coin.
2. Temperature Units: Selects ºF or ºC for the temperature dis-
play. Factory setting is for ºF.
3. Local/Remote Reversing: Preset at the factory; usually for lo-
cal reversing. Remote reversing for use with Reversing Timer
Board only.
4. Empty: Preset at the factory; always ON.
5. Empty: Preset at the factory; always ON.
6. Buzzer Timer: This DIP switch determines the length of time
that the end of cycle buzzer will remain on. "OFF" indicates
that the buzzer will sound for 5 seconds when the drying cy-

DMP Coin

DV and DX Control Suffixes
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Coin
ON ON
ON ON
ON ON
ON OFF
OFF OFF
cle is completed. "ON" indicates that the buzzer will sound
continuously until the STOP button is pressed or the loading
door is opened.
7. Safety Tumble (OPL) or Coin count/Pay (Coin): If DIP
switch #1 is set for OPL, then DIP switch #7 in the ON posi-
tion enables the safety tumble. If DIP switch #1 is set for
Coin, then DIP switch #7 in the ON position enables the dis-
play of the coin count. DIP switch #7 in the OFF position ena-
bles the display of "PAy", to indicate that coins are needed to
run the tumble dryer.
8. Programming: This switch enables or disables the program-
ming feature and should normally be in the OFF position.
84
Always ON
Always ON
5 Sec=Off; Continuous=On
#1 #7
OFF ON
OFF OFF
ON ON
ON OFF
Disable=Off; Enable=On
DIP SWITCH
SAFETY TUMBLE
NO SAFETY TUM-
BLE
COIN COUNT
PAY
Part No. 70457901ENR12