Before Placing Tumble Dryer Into Service - ALLIANCE CA050L Installation Operation & Maintenance

Installation
12. Adjust door catch if necessary to allow
7 – 15 pounds (0.48 – 1.03 bar) pull at center of
handle.
13. Reinstall control assembly using mounting
screws.
14. Reinstall control panel and lint panel.
IMPORTANT: Restore power to tumble dryer and
test for proper operation of loading door switch.
Tumble Dryer should not start with door open; an
operating tumble dryer should stop when door is
opened.
NOTE: If machine is converted back to right hand
hinge operation, the door switch harness must be
rerouted.
1
4
3
1 Switch (New location)
2 Plug (New location)
3 Door Assembly
4 Side Screw
Figure 13
26
2
TMB1997N
TMB1997N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Before Placing Tumble Dryer into
Service
1. Remove or open all panels and check accessible
bolts, nuts, screws, terminals and fittings for
tightness.
2. Check belt tension and adjust if necessary. Refer
to Adjustments section.
3. Replace all panels and guards.
4. Turn on electrical supply to tumble dryer.
5. Open the supply valve for gas or steam heated
tumble dryers.
6. After performing the previous checks, start the
tumble dryer by pressing START. (Refer to the
Operating Manual for detailed instructions.)
Release the start button and open the loading
door. The cylinder should stop rotating within
seven seconds after the door is opened a
maximum of 2 inches (51 mm). If it does not,
adjust the loading door switch. Refer to
Adjustments section.
7. Gas Tumble Dryers: Start the tumble dryer and
check the burner flame. Adjust the air inlet
shutter as required. Refer to Adjustments section.
IMPORTANT: The electronic ignition system will
attempt to light the gas by sparking for the "trial
for ignition" period. If gas does not ignite within
this period, the ignition control will go into a safety
lockout and the valve will no longer open until the
control is reset. It may be necessary to retry several
times to bleed air from the gas lines. To reset, open
and close the loading door and restart tumble
dryer.
70457901ENR7