ALLIANCE CA050L Installation Operation & Maintenance page 43

Non-CE
and Non-
Australian
Models
Recommend- 11 in. w.c.
ed
Minimum 10 in. w.c.
For converting Non-CE models from Natural Gas to L.P. Gas:
050 Series
075 Series
F75 Series
CE GASES refer to Installing CE Gas Drying Tumble Dryers
section, the above data does not apply to the CE.
Turn on gas and check all pipe connections (internal and exter-
nal) for gas leaks with a non-corrosive leak detection fluid. Purge
air in gas service line by operating the tumble dryers in the drying
mode. If burner does not light and unit goes into lockout, open
and close the door and restart. Repeat these steps until burner ig-
nites. Use pipe compound, resistant to actions of L.P. gas, on all
pipe threads.
Check all pipe connections, internal and external, for
gas leaks using a non-corrosive leak detection fluid.
To reduce the risk of explosion or fire, DO NOT USE
AN OPEN FLAME TO CHECK FOR GAS LEAKS! Gas
connections should be checked twice a year for leak-
age.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Australian
and Kore- CE Mod-
an Models
2.74 kPa 27.4 mbar
2.49 kPa 24.9 mbar
M4979P3
M4454P3
M4609P3
WARNING
els
1. Gas Line to Tumble Dryer
2. Gas Supply Piping System
3. Gas "T" Fitting
4. 3 in. [76 mm] Minimum Gas Pipe
5. Gas Pipe Cap
6. Sediment Trap
W635
43
Gas Requirements
2
1
3
6 4
5
TMB2404N_SVG
Figure 22
Part No. 70457901ENR12