ALLIANCE CA050L Installation Operation & Maintenance page 28

Installation
to access upper flange right guide lug assembly. Refer to Fig-
ure 10 .
3. Remove lint panel.
IMPORTANT: Support door and hinge assembly se-
curely to prevent it from dropping once side screws
are removed from door hinge lug.
8
5
7
4
1. Control Assembly Mounting Screw
2. Control Assembly
3. Guide Lug Assembly
4. Side Screw
5. Screw
6. Lint Panel
7. Front Panel
8. Control Panel
4. Remove four front panel screws. Refer to Figure 10 . Keep
door hinge cams in place on door hinge lug. Pull lug and door
assembly off as one piece. Refer to Figure 11 .
5. Remove remaining front panel screws. Refer to Figure 10 .
Disconnect door switch harness from switch. Take off front
panel. Refer to Figure 11 .
6. Exchange switch and plug locations. Depress tabs with an ad-
justable pliers to remove plug and switch from front panel.
Reinstall switch, orienting button toward center of machine.
Reinstall plug in switch's previous location. Refer to Figure
11 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
2
3
4
5
6
TMB1994P_SVG
Figure 10
1
5
1. Plug
2. Switch
3. Side Screw
4. Door Hinge Lug
5. Door Assembly
7. Cut wire ties to remove door switch harness bundle. Be care-
ful not to damage harness wires. Refer to Figure 12 .
8. Reroute door switch harness up through the hole in the right
side of the top panel. Use the panel cutout opening to then put
harness down through the hole in the left side of the top panel
and into the upper left corner of the cylinder enclosure.
28
3
2
4
TMB1995N_SVG
Figure 11
Part No. 70457901ENR12