Save The Laser Settings; Dual-Projection; Add The Projector To A Network - Christie CP42LH Installation Manual

DCI: x = 0.314, y = 0.351
D65: x = 0.3127, y = 0.3290
For more precise adjustments, click the cap on the slider and press the up and down arrow
keys.
6. Repeat steps 4 to 5 until the measured values are approximately the same as the target white
point.

Save the laser settings

1. On the System tab under Configuration Management, click Save.
2. Type a name for the settings file and press Enter.

Dual-projection

For information on setting up two projectors for high-brightness 2D and 3D projection, see the
Christie Duo User Manual (Part Number 020-100978-XX).

Add the projector to a network

1. On the TPC, tap Menu > Communications > Ethernet Settings > Modify IP Settings.
2. To obtain the IP address automatically, tap Automatic then Ok.
3. To specify the settings, tap Manual, type the IP Address, Subnet Mask, and Gateway (optional),
then tap Ok.
4. On the touch panel controller (TPC), tap Menu > Login.
5. In the Username list, select an administrator account.
6. Enter a password in the Password field and tap Login.
7. Tap Menu > Administrator Setup > Communications Configuration.
8. Complete these fields:
Field
Device Name
IP Address
Subnet Mask
Gateway
Apply
Serial Speed (Baud)
Enable SNMP
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
Description
The name of the projector.
The IP address of the projector.
The subnet mask to which the IP address belongs.
The IP address for the network gateway.
Applies Ethernet settings.
The baud rate of the serial port. The default is 115200.
Enables SNMP.
Adjust the Image
68