Replacing a Power Supply
1. Remove the rear access panel (refer to "Removing the Right, Left, and
Rear Access Panels" on page 5).
2. Remove the power plug from the bottom of the power supply (see #1
on Figure 5-3).
3. Disconnect the cables from the top of the supply (see Figure 5-3).
The 5V/12V supply has four cables (#2); the 24V supply has one cable
(#3).
4. Remove the two T-20 screws at the top of the supply (see arrows on
top of power supplies in Figure 5-3).
5. Lift the supply up and out.
Chapter 5
Removal and Replacement
Replacing a Power Supply
5-9