Removing/Replacing The Vertical Encoder Strip - HP SureStore Optical Jukebox 160ex Service Manual

WARNING
CAUTION
Removal and Replacement

Removing/Replacing the Vertical Encoder Strip

Removing/Replacing the Vertical Encoder
Strip
1. Remove the rear access panel (refer to "Removing the Right, Left, and
Rear Access Panels" on page 5).
The edges of the vertical encoder are sharp. Be careful.
Handle the encoder strip with care and ONLY BY THE SOLID SIDE .
The CLEAR side is made up of very fine slits and CAN BE EASILY
DAMAGED.
2. Release the lower end of the vertical encloder strip (see #1 on Figure
5-28).
3. Unhook the top of the encoder strip from the spring and remove
(Figure 5-28).
5-42 Chapter 5