Shipping The Jukebox - HP SureStore Optical Jukebox 160ex Service Manual

Installation
Moving or Shipping the Jukebox
9. Bring the jukebox online according to the customer's system

Shipping the Jukebox

1. Follow the jukebox application software instructions for unmounting
CAUTION Moving the jukebox with a disk in a drive could damage the drive
2. Follow the jukebox application's instructions for labeling the disks
CAUTION Turning off the jukebox in the next step could cause data loss if not done
3. Switch jukebox power off.
4. Remove the right side access panel.
5. Remove the power cord and the SCSI cable connections.
6. Loosen the 1/2-inch nut securing each leveler foot and screw the four
7. Repackage the jukebox in the same way it was received.
2-20
requirements.
and ejecting disks.
Ensure that there are no disks in the drives.
If manually ejecting disks, refer to "Ejecting Disks" in Chapter 3.
mechanism.
Failure to remove all disks from the storage slots in the jukebox could
result in damage to the jukebox.
according to what the customer will be doing with the disks (example:
archiving, moving them to another jukebox, etc.).
correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus
is inactive. Removing power from a SCSI peripheral when the bus is
active can result in data loss and/or indeterminate bus states. Check
the host system manuals for information about checking the SCSI bus
status.
feet up to raise them away from the floor.
Chapter 2