HP SureStore Optical Jukebox 160ex Service Manual page 182

Removal and Replacement
Upgrading Firmware to the Current Revision Level
customer's default configurations should be recorded so that the jukebox
can be correctly restored. Go to the CONF * menu on the control panel to
access and display the current jukebox configurations.
1. Turn the jukebox off.
2. Ensure that your PC tool is off.
3. Remove any cable connections to the single-ended ports on the
NOTE A service SCSI cable is stowed to the left of the drives. This cable is
4. Connect a SCSI cable between your PC tool and one of the
5. Turn the jukebox on.
6. Turn your PC tool on.
7. Follow your download utilities instructions to download the firmware
8. Verify the operation of the drives by running a "random write" for
9. Veify the operation of the jukebox by running the "Wellness Test"
10. Turn off the PC tool and the jukebox.
11. Remove PC tool SCSI cable from the jukebox interface module.
12. Reconnect the customer's cable to the single-ended port (if that was
13. If you downloaded jukebox controller firmware, go to the CONF *
5-60
interface module.
provided in case you need it in the next step.
single-ended ports on the interface module. (Connectors on the
module are high-density.)
Place the interface select switch to the "single-ended" position, if
necessary.
Wait until the jukebox shows READY in the display.
needed (jukebox and/or drives).
approximately two minutes using your PC tool.
from the control panel.
the configuration).
Reset the interface select switch to differential, if necessary.
Chapter 5