Moving Or Shipping The Jukebox; Moving The Jukebox A Short Distance - HP SureStore Optical Jukebox 160ex Service Manual

Moving or Shipping the Jukebox

Moving the Jukebox a Short Distance

1. If removing the disks from the jukebox, follow the jukebox application
software instructions for unmounting, ejecting, and labeling disks to
ensure that the jukebox can be brought online again easily.
Ensure that there are no disks in the drives.
If manually ejecting disks, refer to "Ejecting Disks " in Chapter 3.
Moving the jukebox with a disk in a drive could damage the drive
CAUTION
mechanism.
Turning off the jukebox in the next step could cause data loss if not done
CAUTION
correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus
is inactive. Removing power from a SCSI peripheral when the bus is
active can result in data loss and/or indeterminate bus states. Check
the host system manuals for information about checking the SCSI bus
status. If the computer is connected to a LAN, be sure to check with
the system administrator before turning off power to the jukebox.
2. Switch jukebox power off.
3. Remove the right side access panel.
4. Remove the power cord and the SCSI cable connections.
5. Loosen the 1/2-inch nut securing the leveler feet and screw the feet up
to raise them away from the floor.
6. Carefully move the jukebox to its new destination.
7. Set up the jukebox at its new location.
8. Lower the leveler feet and tighten the 1/2-inch nut on each foot.
Chapter 2
Installation
Moving or Shipping the Jukebox
2-19