Checking The Rfi Adjustments; Figure 5-40 Rfi Clamp On The Gpio And Scsi Cables - HP SureStore Optical Jukebox 160ex Service Manual

NOTE
Figure 5-40
Removal and Replacement

Checking the RFI Adjustments

Checking the RFI Adjustments
The following RFI adjustments must be maintained after servicing the
jukebox.
Depending on the service performed, these configurations may be
altered. The purpose of this section is to remind you of the RFI
adjustments that must remain in place.
Be sure that there is an RFI clamp holding the SCSI and GPIO cable
together as shown in Figure 5-40. (Clamp (#1) has end clips (#2) to hold
the two plates together.
Be sure that there are cable clamps holding the SCSI and GPIO cables to
the side of the jukebox as shown in Figure 5-41.
Be sure that there is an EMI strip installed on the right-side panel as
shown in Figure 5-42.
RFI Clamp on the GPIO and SCSI Cables
5-56 Chapter 5