Convert an MO Jukebox to UDO or Mixed-Media Technology
Install an expansion (lower) power supply
Note:
system.
To install an lower power supply:
1. Place the lower power supply on the brackets below the existing power supplies (see
2. Secure the lower power supply to the jukebox using 2 T-20 torx screws (at the top corners
3. Connect the power switch cable to the lower power supply (see
1
2
3
4
Figure 4: Connect power cable to power supplies
4. Connect the DC power cable to the lower power supply.
5. Route the bundled power supply cables (item 4 in
Note:
proper location and keeping them secure and out of the way.
6. Connect the bundled power supply cables to the lower interposer board, as dictated by the
22
This procedure is required only if you are upgrading a 4- or 6-drive system to a 10-drive
Figure
1).
of the power supply).
Expansion (lower) power supply
Power switch cable to lower power supply
DC power cable to lower power supply
Power supply cables to lower interposer board
supply, below the lower power supply and the drive bays, to the interposer board.
The cable ties have buttons that snap into the jukebox chassis, guiding the cables to their
lengths and connection types.
3
6
5
4
Cable tie (one of several) for power cables
5
AC input power cable to lower power supply
6
Main AC power supply cable from source
7
Figure
3800ux/7100ux Optical Jukebox Conversion Guide
Figure
4).
2
1
7
4) to the right of the lower power