Installing The Server; Rack Compatibility - Sun Oracle SPARC T4-1 Installation Manual

Installing the Server

These topics describe how to install the server into a rack using the rail assembly in
the rackmount kit. Perform these procedures if you purchased the rail assembly.
Note - In this guide, the term rack means either an open rack or a closed cabinet.
Step Description
1. Verify that the rack is compatible with the server's
installation requirements.
2. Take antitilt precautions to ensure the rack does not
tip forward when the server is installed.
3. Attach the slide rails.
4. Install the server in the rack.
5. (Optional) Install the CMA.
6. Verify that the slide rails and CMA (if used) operate
correctly.

Rack Compatibility

Verify that your rack is compatible with the slide rail and cable management arm
options. The slide rails are compatible with a wide range of equipment racks that
meet the following standards.
Item
Structure
Links
"Rack Compatibility" on page 19
"Stabilize the Rack" on page 21
"Install the Slide Rail Assemblies" on page 25
"Install the Server" on page 29
"Install the CMA" on page 31
"Verify Correct Operation of the Slide Rails and the
CMA" on page 36
Requirement
Four-post rack (mounting at both front and rear).
Two-post racks are not compatible.
19