Verify Functionality; Assigning A Static Ip Address To The Sp; Assign A Static Ip Address To The Sp - Sun Oracle SPARC T4-1 Installation Manual

▼ Verify Functionality

●
After powering on the system for the first time, use the Sun Validation Test
Suite (Sun VTS) software to verify the functionality and performance of the
system, including network connections.
Refer to the Sun VTS documentation for instructions on running these test
utilities, available at:
http://www.oracle.com/pls/topic/lookup?ctx=OracleVTS7.0

Assigning a Static IP Address to the SP

"Assign a Static IP Address to the SP" on page 55
■
"Oracle Solaris OS Configuration Parameters" on page 57
■

▼ Assign a Static IP Address to the SP

If the network your server is connected to does not support DHCP for IP addressing,
perform the following procedure to update the OS configuration to static IP
addressing and to assign a static IP address to the SP.
1. Set the SP to accept a Static IP Address.
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
2. Set the IP address for the SP.
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
3. Set the IP address for the SP gateway.
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
Powering On the Server for the First Time 55