Sun Oracle SPARC T4-1 Installation Manual page 62

7. Power on the server and redirect the host output to display on the serial
terminal device:
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
-> start /HOST/console
Are you sure you want to start /HOST/CONSOLE (y/n)? y
Serial console started. To stop, type #.
. . .
After you start the HOST console, the server initialization takes approximately 20
minutes to complete.
8. Configure the OS by entering parameter values as prompted by a series of
onscreen instructions.
Tip – If you are not sure how to respond to a particular value, you can accept the
default and make changes at another time when the OS is running.
Note – You will be prompted to confirm the configuration multiple times. You will
be able to change parameter values if desired at each of these confirmation points.
9. (Optional) Deploy the server for its intended use.
Once the server has been configured and you have changed the default password,
the server is ready for normal use.
Related Information
"Connect a Terminal or Emulator to the SER MGT Port" on page 52
■
"Connecting Cables" on page 39
■
"Assign a Static IP Address to the SP" on page 55
■
54 SPARC T4-1 Server Installation Guide • August 2013