Confirming Specifications - Sun Oracle SPARC T4-1 Installation Manual

Rear Panel System LED Descriptions
TABLE:
LED or Button Icon or Label
Locator LED
and button
(white)
Service
Required LED
(amber)
Power OK
LED
(green)
Related Information
"Front Panel Components" on page 3
■
"Front Panel System LEDs and Buttons" on page 4
■
"Rear Panel Components" on page 6
■

Confirming Specifications

This section contains physical and environmental specifications for the server.
"Physical Specifications" on page 9
■
"Minimum Clearance for Service Access" on page 9
■
"Electrical and Power Specifications" on page 9
■
"Environmental Specifications" on page 11
■
"Acoustic Noise Emissions" on page 12
■
8 SPARC T4-1 Server Installation Guide • August 2013
Description
The Locator LED can be turned on to identify a particular system. When on, it
blinks rabidly. There are two methods for turning a Locator LED on:
• Issuing the Oracle ILOM command set /SYS/LOCATE value=Fast_Blink
• Pressing the Locator button.
Steady on light indicates that a fault has been detected in the system and that
service is required.
Indicates the following conditions:
• Off – System is not running in its normal state. System power might be off.
The SP might be running.
• Steady on – System is powered on and is running in its normal operating
state. No service actions are required.
• Blink – System is running in standby mode and can be quickly returned to full
operation.
• Slow blink – A transitional activity is taking place.
• Fast blink – SP is booting.