Using The Terminal; Battery And Display Information; Gprs Connection Indicators - Ingenico iWL200 series User Manual

7.

Using the Terminal

Switching the terminal on and off
To SWITCH ON the terminal when it is off the base,
press the GREEN ENTER button:
If on the base the terminal will always be powered.
To SWITCH OFF the terminal when off the base, press
both of the buttons shown at the same time:
8.

Battery and Display Information

Your terminal is supplied with a removable, rechargeable battery. This battery recharges
when the terminal is connected to the charger unit.
Following installation, the battery charge status is indicated by the battery icon found in the top
right hand corner of the terminal display.
When you charge the battery for the first time, it should be charged until full capacity is indicated.
This may take from 4 to 16 hours. New terminals are dispatched with some charge present.
Transactions can be performed provided the terminal is connected to the charger unit so that it
can continue charging.
One of these Battery Status Symbols will be displayed
depending on the charge in the battery and whether the
handset is on the base.
9.

GPRS Connection Indicators

The signal icon represents the strength of the GSM
mobile signal. The fewer bars indicated, the poorer the
network strength.
Your terminal may not be able to communicate with the
acquirer if the signal is very poor. The network name
shown next to the signal icon, indicates which network
the terminal is communicating by. This symbol indicates
that the network and SIM card are Active/Installed.
When 'GPRS' is displayed in green it confirms that the
terminal has a GPRS connection.
&
Battery low
Battery fully
charged (off
base)
,
,
Page 9