Network Connections; By Terminal Type - Ingenico iWL250G User Manual

7. Network Connections

This section describes the methods for connecting the software of the payment terminals to a network.
7.1

By Terminal Type

Table 4 shows all the types of network connections that the payment terminals can have.
NB: While terminal-related settings are mentioned, BAXI should also support the same set-up.
Table 4: Network Set-Up by Payment Terminal Type
Payment Terminal Host Comm type
All terminals Ethernet
except iSMP4
iSMP4, ICMP, BT Android
iWL250B &
Move/3500
iSMP4 & Wi-Fi
Move/3500
All terminals via ECR
iCT250E/G and Ethernet
Desk/3500
All terminals Via ECR
except portable
devices e.g. ICMP,
ISMP, Move or IWL
terminals.
iCT250E/G GPRS
GPRS
ECR Comm type Set-Up Process
IP Ethernet - all Ensure that the Ethernet cable is connected.
terminals except
Now go to Function > Comms > Ethernet.
iSMP4, iWL250B/G
and Move/3500 In the ECR menu, set ECR Comm as "IP Ethernet".
Upon reboot, communication between the host and
ECR will be established.
BT Android Requires BAXI to be installed on Android phone.
Connect the phone and terminal via Bluetooth.
IP Wi-Fi ECR and terminal must be connected to the same Wi-
Fi.
USB Slave USB must be connected to the terminal.
Then set ECR = True and Host Comm = USB from
Function menu.
NB: Corresponding settings in BAXI should also be
done to support this set-up e.g. COM port setting.
USB Slave Ethernet and USB cables must be connected to the
terminal.
Set Host Comm and ECR Comm type in the Function
menu.
RS232 RS232 cable must be connected to BAXI.
Set COM port=1 in BAXI.ini. Port 1 is fixed for RS232
connection.
Set same Baud rate in ECR settings and BAXI.ini.
NB: For RS232 integration, a minimum baud rate of
57600 is required.
Now set the Host and ECR Comm types in the
Function menu.
USB Slave SIM must be inserted in the terminal.
Set Host Comm and ECR Comm type in the Function
menu.
No This configuration is for standalone terminals.
Payment Terminals | Page 30 of 54