How To Change A Paper Roll - Ingenico iWL200 series User Manual

4. To assign the terminal to a base unit press the GREEN
button.
To cancel the operation, press the YELLOW button.
5. Choose SELECT BASE and press the GREEN button.
6. Select the number of the base unit you wish to assign
your handset to and press the GREEN button.
You can now proceed to assign your handset to up to two
more base units. Your terminal will return to the READY
prompt when each assignment is complete.
Test Radio Link
To test the quality of the connection, select Test Radio
Link from the Radio Setup menu shown. A 60 second
timer starts if ENTER is selected. A printout is produced,
follow the on screen prompts.

45. How to Change a Paper Roll

1. Hold the terminal securely in one hand. With the other
hand, and by using two fingers, lift the printer cover
release as shown. Fully open the printer cover and
remove the old roll of paper.
2. Unstick the end of the new roll, leaving the end free,
hold the paper roll as shown and carefully place into the
printer compartment.
3. Holding the free end of the paper and the terminal,
close the printer cover and push firmly until it locks.
Holding the yellow CLEAR button will feed the paper
through.
Page 38
SYSTEM
Radio Setup?
Enter=YES Clear=NO
RADIO SETUP
Assign To Base
Select Base
Remove Base
Print Base Info
Test Radio Link
SELECT BASE
40243643
40243582
SIGNAL QUALITY TEST
Press Enter to start
Press Cancel to quit