Battery Operation
The terminal displays the Battery Power status as a number of bars similar to those on a mobile
phone display. There are a number of factors that can affect the rate of Battery drainage. For
example:
•
Length of time off the base
•
Number of receipts per transaction
•
Time before sleep mode is activated
•
Time between transactions.
Depending upon a number of factors, you might experience variation in the number of transactions
performed for each bar on the Battery Power display.
Please check the battery status prior to initiating any action on the handset. Should it indicate 'very
low' (no bars) or 'no power' then you should return the handset to the base to charge the battery.
2.
Important Safety Instructions
Powering down the IWL2xx base
Disconnect the iWL2xxx power supply block adapter from the electrical mains network.
Lithium cell (Backup battery)
The iWL2xx is fitted with an internal lithium cell which can only be accessed by a qualified
technician.
Battery
The iWL2xx is fitted with a battery specially designed for this terminal:
•
Only use the appropriate chargers and batteries listed in Ingenico's catalogue
•
Do not short circuit the battery
•
Do not attempt to remove the battery housing as its components cannot be modified
•
Do not disassemble
•
Batteries at 'end of life' must be disposed of at the appropriates sites.
The lifespan depends on:
•
Features
•
Number of charges and discharge cycles
•
Use temperature.
Warning: There is a risk of explosion if the battery is incorrectly replaced. Never place the battery
next to a heat source or in a fire.
Electrical power outlet
The electrical outlet must meet the following criteria:
•
Must be installed near the equipment and easily accessible
•
Must meet standards and regulations in the country where used
•
The protection of the installation must be set to 20A .
Page 3