4: Advanced Node Board Setup
VGA Jumper Settings (JPG1)
I
2
C to PCIe Slot Jumper Settings (JPI2C1/JPI2C2)
76
Table 4-28
VGA Jumper Settings (JPG1)
Jumper JPG1 (refer to Figure 4-14) enables or disables the
VGA port. The default position is pins 1 and 2 jumpered, which
enables VGA port.
Table 4-29
2
I
C to PCIe Slot Jumper Settings
Notes
Jumpers JI2C1 and JI2C2 (refer to Figure 4-14) enable or
disable I
2
C bus communication with the PCIe slot. Always
set both jumpers to the same setting. If enabled, both
jumpers must be enabled. If disabled, both jumpers must
be disabled.
Notes
VGA Enable/Disable Jumper Settings
JPG1
Jumper
Definition
1-2
Enabled
2-3
Disabled
I
2
C to PCIe Slot Jumper Settings
JPI2C1/JPI2C2
Jumper
Definition
Closed
Enabled
Open
Disabled
007-5466-001