Check The Node Board Setup; Access The Inside Of The Chassis - Silicon Graphics Altix XE320 User Manual

Check the Node Board Setup

Access the Inside of the Chassis

007-5466-001
Use the following sections to open the top cover and check that each node board is properly
installed and all the connections have been made.
Refer to Figure 2-10 when using the following procedure.
1. Remove the screws that secure the system to the rack.
2. Grasp the two handles on either side and pull the system straight out until it locks (you will
hear a "click").
3. Press the locking tabs to release the system from the rack and place it on a stable ESD-safe
work surface.
4. Remove the rack rails from the chassis so that you can gain access to the top cover screws.
5. Remove the four screws (two on the sides and two on the top) that secure the top cover to the
chassis.
6. Place your thumbs in the two rectangular recesses and push the cover away from you
(toward the rear of the chassis) until it stops.
7. Lift the top cover from the chassis to gain access to the inside of the server.
Note: To remove the system from the rack completely, depress the locking tabs in the chassis
rails (push the right-side tab down and the left-side tab up) to continue to pull the system out
past the locked position.
Check the Node Board Setup
21