Oki MB760 Service Manual page 341

05/ Sub
Mode Element
08 element
08 Setting System User
Mode interface
08 Setting System Network
Mode
08 Setting System User
Mode interface
08 Setting System Network
Mode
08 Setting System General
Mode
08 Setting System Maintenance Notification of
Mode remaining amount
of toner
08 Setting System Maintenance Notification of
Mode remaining amount
of toner
08 Setting System Maintenance Notification of
Mode remaining amount
of toner
08 Setting System User Card reading
Mode interface device
08 Setting System General
Mode
08 Setting System Maintenance Display of
Mode remaining life (for
RDMS/MMDT)
45641001TH Rev.1
Sub-
Item Subitem Code
code
8745
8746
8748
8749
8750
8755
8756 0
8756 1
8758
8761
Toner 8762 0
Default Acceptable
Details RAM
value value
Enable/Disable 0 0-1 SYS Sets whether part of the cookie, password, and form data
setting of EWB
history
Port number 162 1-65535 NIC Sets the port number of destination 10 for sending SNMP
setting of
destination 10 for
sending trap
Input of 0 0-1 SYS 0: Not required
department code at
user authentication
User authentication 0 0-1 SYS 0: Disabled
by logon
information to
domain (external
authentication)
Time to wait for 0 0-1 SYS Sets whether the drum idling is executed or not when the
print image
Enable/Disable 0 0-1 SYS 0: Disabled
setting
Remaining amount 25 0-100 SYS 0 to 100%
at first notification
Notification interval 10 1-25 SYS 1 to 25%
Overwriting of login 0 0-1 SYS Switches the enable/disable setting for the function to
at authentication
Retention of print 0 0-1 SYS Use this code to retain and obtain the print data (spooling
(spooling) data
SYS 0 ~ 100%. The small value indicates that the remaining
K 0 0-100
Oki Data CONFIDENTIAL
Contents
of user who logs in to EWB is saved or not.
0: Disabled
1: Enabled
trap. If the port is used when using the real time log
notification function, change the port number.
1: Required
1: Enabled
waiting for print image occurred. If there is the stain on
the back side of the paper, set the value of this code to
"1". When the value is set to "1", the number of times the
equipment stops printing may increase.
0: Waiting is enabled (8 sec.)
1: Waiting is disabled (0 sec.)
1: Enabled
overwrite the login information at the card authentication.
0: Disabled
1: Enabled
data) if problem occurs. After obtaining the data, be sure
to disable the setting.
0: Disabled (print data is deleted)
1: Enabled (print data is retained)
life is short.
Proce-
dure
1
12
1
1
1
1
4
4
1
1
14
11-43 /