Page 3
Oki Data assumes no responsibility to the damages caused or claimed to have been caused by the user as a result of repair, adjust- ment and/or change using this manual.
Oki Data CONFIDENTIAL REPLACEMENT OF PARTS This chapter describes the procedures of the field replacement of parts, assemblies and units. The procedures are to detach them. Reverse the procedures to attach them. ① ② The reference part numbers used in this manual (such as ) do not identical to the part numbers in the maintenance disassembly configuration diagram (45479001TL) and RSPL (45479001TR) for the manual.
Page 5
1. REPLACEMENT OF PARTS Oki Data CONFIDENTIAL 1.1 Notes for Replacing of Parts (2) Do not disassemble it if the printer works normally. (1) Prior to replacing a part, unplug the AC cord and the interface cable. (3) Disassemble it as required. Do not remove the part that is not shown in (a) Be sure to use the following procedure to unplug the AC cord: the replacement procedure.
Page 6
1. REPLACEMENT OF PARTS Oki Data CONFIDENTIAL Maintenance Tools: Screws in use: Table 1-1-1 shows the tools necessary to replace printed-circuit boards and units: Shape Designation Table 1-1-1: Maintenance Tools Screw(silver) Maintenance Tool Q'ty Remarks No. 2-200 3 to 5mm...
1. REPLACEMENT OF PARTS Oki Data CONFIDENTIAL 1.2 Parts Replacement procedure This Section contains the parts replacement for parts and assemblies. 1.2.1 Board-GOH-12 etc ⑧ ⑨ ⑩ ① and remove the Remove the two screws (Silver,No:41723901) ⑧ ⑩ Joint ② ,and remove the Option Tray from MFP.
1. REPLACEMENT OF PARTS Oki Data CONFIDENTIAL (2) Remove the rollers ① , ② while warping each latch. 1.2.2 Paper Feed Roller In the hopping jam occures frequently, to change the pickup roller and the separation roller. feed roller pickup roller...
Page 9
REPLACEMENT OF PARTS Oki Data CONFIDENTIAL (4) Set the new roller (without gear) ② to the shaft. ② Note! Check that the two rollers do not come off. (5) Return the cassette to the main body. 9 / 9 45479001TH Rev.1...