Oki MB760 Service Manual page 274

(14) Restore the key and license data by following the steps below.
• Restore the key data by pressing the [1] key to select "1. Key SRAM to FROM", then
press the [START] button.
• If the state of "FROM Licence Status" is "KeyMismatch", restore the license data by
pressing the [3] key to select "3. License SRAM to FROM ", then press the [START]
button.
• If ADI-HDD is installed, restore the encryption key data by pressing the [5] key to
select "5. ADIKey SRAM to FROM", then press the [START] button.
(15) Press the [ON/OFF] button to shut down the equipment.
(16) Initialize the updated data by following the steps below.
• Turn the power ON by pressing the [ON/OFF] button while holding down the [0] and [8]
keys simultaneously.
• Key in "9030", and then press the [START] button.
• Press the [INITIALIZE] button.
[B] Confirmation of the updated data
After the updating is completed, check each data version in the Setting Mode (08) to
confirm that the data was overwritten properly.
 P. 8-28 "8.6 Confirmation of the updated data"
45641001TH Rev.1
Oki Data CONFIDENTIAL
8-24 /