Oki MB760 Service Manual page 136

[F102] HDD start error
[F103] HDD transfer time-out
[F104] HDD data error
[F105] HDD other error
Classification
Other service call
Check item
HDD
Replacement part
HDD
SYS board
[F106_0] aDI-HDD error: Illegal disk replacement detected (aDI-HDD exchange to saTa-
HDD)
Classification
Other service call
Check item
Setting
HDD
45641001TH Rev.1
HDD start error: HDD cannot become "Ready" state.
HDD transfer time-out: Reading/writing cannot be performed in the
specified period of time.
HDD data error: Abnormality is detected in the data of HDD.
HDD other error
• Connector and harness check
• Check if the connector pins of the HDD are bent.
• Perform the bad sector check (08-9072). If the check result is OK,
recover the data in the HDD. If the check result is failed, replace the
HDD.
ADI-HDD error: The ADI-HDD has been replaced illegally to SATA-HDD
(normal type).
Check if the HDD has been replaced with a SATA-HDD (normal type).
1. Start the equipment in the 4C mode: [4] + [C] + [POWER]
2. Check the type of the HDD shown on the top left of the control panel
display "Current HDD type".
2a. In case of "SATA-HDD" (normal type), replace it with the original
ADI-HDD or a new ADI-HDD.
Notes:
To replace with the original ADI-HDD, start the equipment in
the normal mode and then reinstall system software only if any
abnormality occurs.
2b. In case of "ADI-HDD"
Check each item in the Measures field for the HDD below.
If the error still occurs, reinstall the system software.
• Connector check
• Harness check
Follow the procedure below if no abnormality is found in the check items
above.
1. Start the equipment in the 4C mode: [4] + [C] + [POWER] → 1. Revert
factory initial status HDD
2. Reinstall the system software.
Oki Data CONFIDENTIAL
Contents
Measures
Measure
Error item
Measures
5-53 /