Main Control Panel - Quantum Data 980 DP User Manual

980 DP Video Generator - User Guide
Network Analyzer – Dashboard Items
 Card –The Card area shows the current module whose port is being displayed on the Network Analyzer
Video Generator module.
 Port –The Port area shows the current Rx port that is being displayed on the Network Analyzer.

. Currently the only analyzer port is the 980 HDMI Video Generator port.
Second Row Items:

Lanes

Bandwidth

Active (video resolution)

V Total
Third Row Items:

Res[olution]
from the main stream attributes.

Total (video) pixels and lines
determined from the main stream attributes.

Sync
and the number of vertical lines in the blanking and its polarity (e.g. 5 lines, positive).

Start
attributes.

Colorimetry and bit depth
atttributes.

Scan - The scan type used, progressive (e.g. Prog) or interlaced (Inter) determined from the main
stream attributes.
Fourth Row Items:

Sync -Clk
synchronous. A value of N means async; a value of Y means synchronous. This value is determined by the
main stream attributes.

Stereo-3D

Mute - The AudioMute flag status determined from the main stream attributes.

HDCP-Sync
for HDCP sync not detected.

Mvid
atttributes.

Nvid
atttributes.
8.3

Main Control Panel

This subsection describes the main control panel for the Network Analyzer. Refer to the table below for a
description of these controls.
Page 165
- The number of lanes used during link training.
- The lane rate (per lane).
- This is the measured total vertical video lines per frame.
- The active video resolution in horizontal pixels and vertical lines determined
- The number of horizontal pixels in the blanking and it polarity (e.g. 44 pixels, positive)
- The starting pixel and line in the active video determined from the main stream
- Indicates if the Link Clock and Main Video Stream clock are asynchronous or
- The status of 3D audio determined from the main stream attributes.
- The HDCP sync detect of the Video Blanking VB-ID bits. Y for sync detected; No
- The Mvid value used for stream clock recover. This is determined from the main stream
- The Nvid value used for stream clock recover. This is determined from the main stream
. Currently the only analyzer module (card) is the 980 HDMI
- This is the measured video resolution.
- The total video in horizontal pixels and vertical lines
- The colorimetry and bit depth determined from the main stream
Rev. A4
July 14, 2014