Mitsubishi Apricot LS Series Owner's Handbook Manual page 67

How to Install a Processor
To install a processor, follow these steps:
1. Install the retention mechanism.
2. Install the processor.
3. Set the processor speed.
Detailed instructions for each of these procedures follow.
NOTE
If you are installing a boxed Intel Pentium II processor, see the
instructions on page 4/6.
Install the Retention Mechanism
NOTE
To install the retention mechanism, you need a Phillips (#2 bit)
manual torque screwdriver capable of a 6.0 in.-lb. ± 1.0 in.-lb.
(0.678 N-m ± 0.113 N-m) setting. The screwdriver also must
have a shaft longer than 2 inches.
To install the retention mechanism, follow these steps:
1. Observe the precautions in 'Before You Begin'
(Chapter 2).
2. Locate the Slot 1 connector and the four attachment
studs.
U p g r a d i n g
LS700 HANDBOOK 4/3