Mitsubishi Apricot LS Series Owner's Handbook Manual page 48

How to Set the Processor Speed
Set the processor speed after you have installed or upgraded
the processor. This procedure assumes that the motherboard
is installed in the computer and the configuration jumper
block is set to normal mode.
1. Observe the precautions in 'Before You Begin'
(Chapter 2).
2. Turn off all peripheral devices connected to the
computer.
3. Turn off the computer and unplug the power cable.
4. Remove the computer top and access covers.
5. Find the configuration jumper block (see Figure 22).
6. Place the jumper on pins 2-3 as shown below.
J8B2
3
1
OM06240B
7. Replace the cover, turn on the computer, and allow it
to boot.
8. The computer starts the Setup program. Setup displays
the Maintenance menu.
9. Use the arrow keys to select the Processor Speed feature
and press <Enter>. Setup displays a popup screen with
the available processor speeds.
10. Use the arrow keys to select the processor speed. For
example,
Pentium II processor. Press <Enter> to confirm the
speed. This Maintenance menu reappears again.
11. Press <F10> to save the current values and exit Setup.
12. Turn off the computer.
S y s t e m m o t h e r b o a r d
select 266 for
LS700 HANDBOOK
a 266 MHz
3/5