Mitsubishi Apricot LS Series Owner's Handbook Manual page 23

Installing the Access Side Cover
Removing the Non-Access Side Cover
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Check that you have not left any tools or loose parts
inside the chassis. Check that everything is properly
installed and tightened.
3. Holding the side cover at a slight angle, insert the tabs
at the front of the cover into their slots. Swing the
cover snugly against the chassis.
4. Slide the tabs at the rear of the cover down as far as
they will go. It may be necessary to apply pressure
against the side cover in order to properly seat the tabs.
The non-access side is the left side of the chassis when
viewed from the front.
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Remove the top cover.
3. Lay the chassis temporarily on the access side.
4. Release the plastic tab on the top of the cover (see
Figure 6).
5. Release the two plastic tabs on the bottom of the side
cover then carefully pull the rear end of the cover away
from the chassis and unhook it from the front bezel.
◊ You may have to use a little pressure to overcome
snap-in fixings under the side cover.
C h a s s i s a n d C o m p o n e n t s
LS700 HANDBOOK 2/5