Mitsubishi Apricot LS Series Owner's Handbook Manual page 31

Installing the Floppy Diskette Drive Carrier
Removing the main Peripheral Carrier
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Insert the tabs on the carrier into their slots on the
main peripheral carrier.
3. Slide the carrier all the way forward until the screw
holes in both carriers line up.
4. Insert and tighten the screws that hold the two carriers
together.
5. If there is a drive in the carrier, attach the power cable
and the ribbon cable to the drive.
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Remove the top cover.
3. Remove the access side cover.
4. Remove the bezel.
5. Remove the floppy diskette drive carrier.
6. If there is an EMI shield installed for the bottom bay,
remove it.
7. Disconnect the power cables and the ribbon data cables
from any drives in the carrier.
8. Remove the two screws that secure the carrier to the
front of the chassis. (See Figure 12).
9. Place the chassis on its back and remove the two screws
that secure the carrier to the bottom of the chassis.
10. Lift the carrier up and remove it from the chassis.
C h a s s i s a n d C o m p o n e n t s
LS700 HANDBOOK 2/13