Add-In Cards - Mitsubishi Apricot LS Series Owner's Handbook Manual

C h a s s i s a n d C o m p o n e n t s
Installing the Bezel

Add-in Cards

Removing an Expansion Slot Cover
2/8 LS700 HANDBOOK
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Lift the front of the chassis slightly and align the bezel
with the chassis. You may find it easier to place the
chassis on its back when aligning the bezel.
3. Press the top of the bezel against the chassis until the
tabs click into place.
The following procedures tell how to remove and install slot
covers and add-in cards.
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Remove the top cover.
3. Remove the access side cover.
4. Remove the two screws that hold the slot cover bracket
to the chassis (Figure 8, A).
5. Swing the bracket away from the chassis and remove it
(Figure 8, B).
Figure 8. Removing the Expansion Slot Cover
Bracket
B
A