Installing An Add-In Card - Mitsubishi Apricot LS Series Owner's Handbook Manual

Removing an Add-in Card
Figure 10. Installing an Add-in Card
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Disconnect any cables attached to the add-in card you
are removing.
3. Remove the two screws that hold the slot cover bracket
to the chassis.
4. Swing the slot cover bracket away from the chassis and
remove it.
5. Hold the card at each end and carefully rock it back
and forth until the edge connectors pull free.
6. Store the card in an antistatic wrapper.
7. If you disconnected cables from the card and you are
not reinstalling this card or one like it, remove the
cables from the computer.
8. Install an expansion slot cover over the vacant slot.
C h a s s i s a n d C o m p o n e n t s
LS700 HANDBOOK 2/11