Removing An Expansion Slot Cover - Mitsubishi Apricot LS Series Owner's Handbook Manual

Installing an Expansion Slot Cover
6. Insert a flat blade screwdriver into a hole of the slot
cover you wish to remove. (See Figure 9).
7. Move the screwdriver up and down until the slot cover
breaks away from the chassis. Lift the slot cover out of
the chassis.
Figure 9. Removing an Expansion Slot Cover
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Using a standard metal slot cover, insert the cover into
the slot.
3. Hold the slot cover bracket at an angle to the chassis
and line the holes in the bracket up with the tabs on
the chassis.
4. Pivot the bracket so the screw holes in the bracket and
the chassis line up (see Figure 8, A).
5. Secure the bracket to the chassis with two screws.
C h a s s i s a n d C o m p o n e n t s
LS700 HANDBOOK 2/9