Other Chassis Components - Mitsubishi Apricot LS Series Owner's Handbook Manual

Other Chassis Components

Removing the Fan/card Guide Module
Installing the Fan/Card Guide Module
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Remove any add-in cards that block the module.
3. If there is a fan installed in the module, disconnect the
fan's power cable from the motherboard.
4. Swing the module away from the non-access side of the
chassis by squeezing the long edge to release the tabs
and pulling on it.
5. Swing the module out until the module comes free
from the chassis.
◊ Do not use excessive force as it may damage the
mounting tabs.
Figure 18. Removing the Fan/Card Guide
Module
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
C h a s s i s a n d C o m p o n e n t s
LS700 HANDBOOK 2/23