Installing The Processor Retention Mechanism - Mitsubishi Apricot LS Series Owner's Handbook Manual

U p g r a d i n g
4/4 LS700 HANDBOOK
Figure 26. Installing the Processor Retention
Mechanism
B
D
A Slot 1 connector
B Attachment studs
C Retention mechanism
3. To position the mechanism, orient it as shown in
Figure 26. The connector tab fits into a notch in the
base of the mechanism. When properly seated, the base
of the mechanism is flush with the motherboard.
CAUTION
Overtightening the captive nuts on the retention mechanism can
damage the motherboard. Tighten the captive nuts to no more
than 6.0 in.-lb. ± 1.0 in.-lb. (0.678 N-m ± 0.113 N-m).
4. Finger tighten all four captive nuts to make sure they
start correctly on the threads of the attachment studs.
5. To secure the mechanism, tighten the captive nuts with
the torque screwdriver to no more than 6.0 in.-lb.
± 1.0 in.-lb. (0.678 N-m ± 0.113 N-m).
E
A
OM06225
D Connector tab
E Captive nuts
C