Exit Menu - Mitsubishi Apricot LS Series Owner's Handbook Manual

B I O S a n d s e t u p
Removable Devices Submenu
Options
• Legacy Floppy
Drives

Exit Menu

Feature
Exit Saving Changes
Exit Discarding
Changes
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
5/16 LS700 HANDBOOK
Use this submenu to configure the boot sequence for
removable devices.
Description
Specifies the boot sequence for the removable
devices attached to the computer. To specify boot
sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <+> to move the device up the list or <->
to move the device down the list.
The operating system assigns a drive letter to each
device in the order listed. Changing the order of
the devices changes the drive lettering.
Use this menu to exit the Setup program, save changes, load
defaults, and save defaults.
Description
Exits and saves the changes in CMOS RAM.
Exits without saving any changes made in Setup.
Loads the default values for all the Setup options.
Loads the custom defaults for Setup options.
Saves the current values as custom defaults.
Normally, the BIOS reads the Setup values from
flash memory. If this memory is corrupted, the
BIOS reads the custom defaults. If no custom
defaults are set, the BIOS reads the factory defaults.
Discards changes without exiting Setup. The values
present when the computer was turned on are used.