Removing The Floppy Diskette Drive - Mitsubishi Apricot LS Series Owner's Handbook Manual

Table of Contents

Advertisement

Removing the floppy Diskette Drive

1.
Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2.
Remove the drive carrier.
3.
Remove the three screws holding the diskette drive to
the carrier (see Figure 13).
4.
Slide the drive out of the carrier.
5.
If you are not replacing the drive you just removed, and
there are no other diskette drives on the same data
cable, disconnect the cable from the motherboard.
NOTE
A diskette drive or a suitable blanking insert must be installed
in this bay to preserve the electromagnetic emissions
characteristics of the chassis and to ensure proper cooling of the
computer components.
6.
Install the drive carrier back into the chassis.
Figure 13. Removing the floppy Diskette Drive
C h a s s i s a n d C o m p o n e n t s
A
LS700 HANDBOOK
2/15

Advertisement

Table of Contents
loading

Table of Contents