Upgrading; Processor - Mitsubishi Apricot LS Series Owner's Handbook Manual

4

Processor

Remove the Installed Processor

UPGRADING

This computer uses the Intel Pentium
supplied as a module complete with heatsink. At the time of
writing processors rated at 233MHz, 266MHz and
300MHz are available.
To remove the installed processor, follow these steps:
1. Observe the precautions in 'Before You Begin'
(Chapter 2).
2. Turn off all peripheral devices connected to the
computer. Turn off the computer.
3. Remove the computer cover.
4. Remove the motherboard from the computer chassis.
5. Place the motherboard on a flat work surface and
remove any components that block access to the
installed processor.
6. Remove the top bar of the heatsink support from the
base as shown in Figure 25. Press in on the latches to
release the top bar.
®
II processor, which is
LS700 HANDBOOK 4/1