Installing Full-Width Devices - Mitsubishi Apricot LS Series Owner's Handbook Manual

Installing Full-width Devices

Installing a Full-width Device
NOTE
A magnetic Phillips screwdriver will be useful for this
procedure, but keep it well clear of any loose floppy disks or tape
cartridges.
1. Observe the precautions in 'Before You Begin', at the
beginning of this chapter.
2. Switch off the computer and remove the power cable.
3. Remove the top cover.
4. Remove the access side cover.
5. Remove the non-access side cover.
6. Remove the plastic filler panel from the desired bay.
7. Remove the EMI shield from the desired bay.
8. Remove the device from its protective wrapper and
place it on an antistatic surface.
9. Set any jumpers or switches on the device according to
the manufacturer's instructions.
10. Connect the data cable to the motherboard (if
required) if it is not already connected.
11. Slide the device into the bay and secure it with four
screws (not supplied).
12. Connect power and data cables to the device.
13. If you do not need access to the front of the device,
replace the EMI shield and the plastic filler panel.
C h a s s i s a n d C o m p o n e n t s
LS700 HANDBOOK 2/21