Error Messages - Mitsubishi Apricot LS Series Owner's Handbook Manual

T r o u b l e s h o o t i n g
SCSI Drives

Error Messages

PCI Configuration Error Messages
Message
Bad PnP Serial ID Checksum
Floppy Disk Controller
Resource Conflict
NVRAM Checksum Error,
NVRAM Cleared
NVRAM Cleared By Jumper
6/6 LS700 HANDBOOK
that the permission assigned by the operating system allow
the intended access.
If you have just fitted a new SCSI drive, or device, check
that you have used a valid 'ID' that does not conflict with
other SCSI drives or devices is the system. Look in any
documentation for information.
On boot up, just after POST, a list is displayed of the
devices attached to the SCSI interface, which shows the
device, its parameters and the set 'ID'.
Some of these messages may indicate a serious fault with the
system and may cause the POST to halt. If the message
persists, make a note of it and call your supplier or
authorised maintainer.
The following PCI messages are displayed as a group with
bus, device and function information.
Explanation
The Serial ID checksum of a Plug and
Play card was invalid.
The floppy disk controller has requested a
resource that is already in use.
The ESCD data was reinitialized because
of an NVRAM checksum error. Try
rerunning the ICU.
The "CMOS Clear" jumper has been
moved to the "Clear" position and
CMOS RAM has been cleared.